Balsa kit

Balsa kit

Balsa kits come in many sizes and skill levels. The balsa wood may either be cut with a die-cut or laser. Laser cut kits have a much more precise construction and much tighter tolerances, but tend to cost more than die-cut kits. Die-cut kits can work and look just as good with a little sanding, cutting and use of basic woodworking principles.

The kit usually contains most of the raw material needed for an unassembled plane, a set of (sometimes elaborate) assembly instructions, and a few spare parts to allow for builder error. Assembling a model from plans or a kit can be very labor-intensive. In order to complete the construction of a model, the builder typically spends many hours assembling the frame, covering it, and polishing/refining the control surfaces for correct alignment. The kit does not include necessary tools, and these have to purchased separately. A single overlooked error during assembly could compromise the model's airworthiness, leading to disaster and making you really mad.

Smaller balsa kits will often come complete with the necessary parts for the primary purpose of non-flying modeling or rubber band flight. These kits will usually also come with conversion instructions to fly as glow (gas powered) or electric and can be flown free-flight or radio-controlled. Converting a kit requires additional and substitution parts to get it to fly properly such as the addition of servos, hinges, speed controls, control rods and better landing gear mechanisms and wheels.

Many kits will come with a tissue paper covering that then gets covered with mulitple layers of plane dope which coats and strengthens the fuselage and wings in a plastic-like covering. It has become more common to cover planes with heat-curing plastic films ("heat shrink covering" or "solarfilm") that can be ironed on - a hand-held iron causes the film to shrink and adhere to the frame. This plastic covering is more durable and makes for a quick repair. Other varieties of heat shrinkable coverings are also available, that have fibrous reinforcements within the plastic film, or are actual woven heat shrinkable fabrics.

It is common to leave landing gear off smaller planes (roughly 36" or smaller) in order to save on weight, drag and construction costs. The planes can then be launched by throwing and can then land in soft grass.